OHL.ST · OHL.SK

Multi-point lock bodies

Lock bodies for aluminium doors and windows: multi-point bodies with two locking points, single-point bodies, and passage bodies for leaves that do not lock. Faceplate length, backset and centres are read from the catalogue drawing of each body.

Models on this page

101–104

Catalogue pages

Multi-point, single-point, passage

Body types

Range overview

What this category covers

Mortise lock bodies for door and window sets with matching locking plates, face plates and keepers. Photographs and figures on this page come from the AOHUALUN printed catalogue, and the catalogue pages are named with each table so a buyer can check them against an existing copy.

Zinc-plated multi-point lock body with a long faceplate and two locking points — OHL.ST multi-point lock body — catalogue pp. 101–102

Zinc-plated lock body seen from the faceplate side — OHL.ST lock body — catalogue pp. 101–102

Lock body with a short faceplate and a single locking point — OHL.ST lock body — catalogue pp. 101–102

Representative models

Models, codes and parameters

Codes are printed exactly as in the catalogue, so a repeat order can be matched line by line. Parameters are the ones the catalogue gives for each model; where the catalogue gives no figure, the cell is left out rather than estimated.

Lock bodies OHL.ST

Faceplate is the overall plate length by plate height. Backset is the distance from the faceplate to the spindle; the centres column gives the hole spacing printed on the drawing (85 / 92 means the body is made in both spacings).

Lock bodies OHL.ST
Model	Body type	Faceplate L × H (mm)	Backset (mm)	Centres (mm)
OHL.ST-29	Multi-point	340 × 29	42	85 / 92
OHL.ST-34	Multi-point	340 × 34	47	85 / 92
OHL.ST-20	Single-point	210 × 20	35	85 / 92
OHL.ST-25	Single-point	210 × 25	40	85 / 92
OHL.ST-30	Single-point	210 × 30	45	85 / 92
OHL.ST-35	Single-point	210 × 35	50	85 / 92
OHL.ST-217	Passage	130 × 25	40	43
OHL.ST-218	Passage	130 × 30	45	43

The same section lists patterned multi-point bodies (OHL.ST-30 in the patterned version), drive boxes (OHL.SH) and keep plates (OHL.SK). Ask for the complete list of bodies and keeps. Source: Catalogue pp. 101–104.

This selection shows 8 representative models. The catalogue carries more sizes and finishes in the same families — ask for the complete model list and we will send the codes, drawings and the trade terms for your order.

Selection notes

What to check before ordering

These notes come from the catalogue pages named above and from the fitting information printed with the same family.

Door leaves are usually cut for a 85 or 92 mm centre distance; check the existing body before ordering, because both are made in the same faceplate sizes.
Passage bodies (OHL.ST-217 and ST-218) have no locking function and are used on leaves that only need a handle and a latch.
Faceplate height has to fit the groove in the profile: bodies run from 20 to 35 mm high in the same 210 mm length, so a taller plate is not a drop-in replacement.

Request the complete model list

Send the models you already use, or the window type and profile you are building, and we will answer with the matching codes, drawings and the trade terms for your order. Trade terms are quoted per order and are not published on this site.

NextCylinders for these bodies NextHinged door hardware All productsBack to the product overview